Table of Contents
Advertisement
Veo17 Embedded DVR
15. Setup Menu: Storage
Selecting Storage from the Setup Menu provides the ability to configure newly installed
hard drives initialize the drives and under the "Advanced tab set Quotas for each channel.
General:
This displays the hard drive/s installed on the Veo17 with their basic
information. At the bottom is displayed the total capacity and free space of all connected
storage drives (does not include USB connected storage for back up).
The buttons along the bottom provide an opportunity to add a new drive or to Initialize the
drives which will be required for newly installed drives. Note that initializing a disk will
erase all the data on the drive.
Click the "Edit" button to open the local Storage Settings window.
Here you can set the Storage Property from R/W (read/ write), Read-only, and Redundancy.
There must be one drive present set to R/W. The second drive may be set to Read-Only or
Redundancy.
If there is only one drive the default Group will be 1 and contain all the channels. Groups
can be used to set which channels record to which drive. If a second drive is available it
can be assigned a group and in the advanced tab have channels assigned to record on it.
To support a group the drive must be set to R/W.
A second drive set to redundancy will mirror the R/W drive for data security. If the primary
drive fails for whatever reason the data is also stored on the second drive.
A drive set to Read-only will only be available for search functions. New data will not be
recorded and the data stored on the drive will not be overwritten.
Advanced:
Mode: Select between Group or Quota.
• Quota: Set a Quota for each channel limiting the amount of hard drive space the
channel can use. With Quota selected from the Mode selection menu proceed to select
the required channel from the drop down. The used Record Capacity is displayed
and the Storage Capacity. The Max. Record Capacity can be set in GBs. Use the soft
keyboard to enter the Max Capacity for the channel. Click the copy button at the bottom
if all channels are to have the same settings. Enable Storage Sleeping to allow the
drives to remain at rest if they are not being used.
• Group: Select Group from the Mode selection menu. If there is one hard drive installed
on the machine there can be only one group. If there is a second drive that drive can
be assigned as a second group. Select which group to set then select which channels
will record on that group. Click Apply to save the settings.
15. Setup Menu: Schedule
Schedule each channel to perform different types of recording not only for each day but at
different times of the day as well as set special holiday recording.
Schedule:
This shows how each channel is configured
for scheduling. Each day is listed and the hour of the day
is across the top (24 hour clock). Select a different channel
from the drop down list to see its schedule displayed. The
type of recording is represented by the color applied to the
record progress bar. In the example above On Mondays
Channel 1 on is scheduled to record Motion from 00:00 to
08:00 then change to VA recording until 17:00 and record
Continuously until 24:00.
To edit and configure the scheduling:
• Select which channel from the drop down list to have the
scheduling configured.
• Click the edit button on the right. This will open the scheduling window.
Page 9
Veo17
Rev.
170119
Advertisement
Table of Contents
