Table of Contents
Advertisement
Veo17 Embedded DVR
Network Detection:
Traffic:
Check the network traffic to get real-time information for the Veo17 such as linking
status, MTU, and sending/receiving rate. Traffic rate is refreshed every second.
Network Detection:
See and test the status of network connections of the Veo17. Check delay and packet
loss.
• Select a NIC to test network delay and packet loss.
• Enter the destination address in the Destination Address field.
• Click the Test button to start testing the network delay and packet loss.
By connecting the DVR to a network, the captured network data packet can be exported
to the USB connected backup device. To Export the Network packet:
• Select the backup device from the device name drop down list. (Note the device will
need to be connected to the USB port on the back panel of the Veo17.)
• Click the Export button to start exporting.
• After the exporting is complete, click OK to finish he packet export. Up to 1M of data
can be exported each time.
The network status can be examined from this interface.
•
Click the Status button a message box will appear and inform if the Network status
is normal or if there is a problem.
•
Click the Network button at the bottom to open a quick settings interface. These
are the same settings explained under System Management/ Network/ TCP IP
Network Status:
View the bandwidth of Remote Live View, bandwidth of Remote Playback, and bandwidth
of Net total Idle. Click the refresh button to get the latest bandwidth statistic.
Storage Detection:
This is a monitoring system for the HDD installed in the Veo17 to detect and report on
various indicators of reliability to anticipate any failures.
S.M.A.R.T. Settings:
• Select the HDD to view the smart information list associated with that drive. If it is
necessary to continue to use the drive even after it has failed a SMART check, click the
Continue to use this disk when self-evaluation is failed.
• To perform the S.M.A.R.T. test click
a self S.M.A.R.T test. It will take a few minutes to complete. Once it is completed the
Self Test Status filed will contain the result. When it passes it will display, Self-test
succeeded.
• The S.M.A.R.T. statistics are displayed at the bottom under the S.M.A.R.T. Information
heading.
Bad Sector Detection:
Run a scan of the Hard drive to check the status. The scan will uncover any damaged
sectors on the drive.
• Select which Drive to scan from the Storage No. drop down list.
• Select either Key Area Detection or Full Detection.
• Click the Detect button to start the scan.
• Any error information will be displayed on the right side of the screen.
Page 19
Veo17
the button. The Veo17 will start
Rev.
170119
Advertisement
Table of Contents
