Table of Contents
Advertisement
Veo17 Embedded DVR
Network:
DDNS:
• Enable DDNS: Check to enable DDNS. this will activate the setting below for
configuration.
• DDNS Type: There are 4 DDNS types to select from, IPServer, DynDNS, PeanutHull,
NO-IP and HiDDNS.
• Server Address: Enter the server address.
• Complete the further required fields. These will change depending on the DDNS type
chosen above but include Domain User Name and Password.
• Click Apply to save the settings.
TCP/IP:
• NIC Type: Displays the type of Network Interface Card installed in the device. The
Veo17 comes with a 10M/100M/1000M Self-adaptive NIC card.
• Enable DHCP: Click to Enable DHCP on the Veo17.
• IPv4 Address: Displays the current IPv4 Address. This address can be changed with the
soft keyboard.
• IPv4 Subnet Mask: Displays the Subnet Mask. This can be changed with the soft
keyboard.
• IPv4 Default Gateway: Displays the Default Gateway. Change the gateway with the soft
keyboard.
• IPv6 Address1: Will display and allow changing of the IPv6 address if one is assigned.
• IPv6 Address2: Will display and allow changing of a second IPv6 address if one is
assigned.
• IPv6 Default Gateway: Displays and allows the setting of the IPv6 Gateway
• MAC Address: Displays the MAC Address of the machine.
• MTU (Bytes): Displays the maximum transmission unit. The Default is 1500 and it is
recommended that the setting remain at 1500.
• Preferred DNS Server: Enter the Preferred DNS Server for the Veo17.
• Alternate DNS Server: Add the address of a backup Alternate DNS Server.
• Click Apply to save the settings.
PPPOE: (Point to Point Protocol over Ethernet)
• Enable PPPOE: Click to Enable the PPPOE
• User Name: Once PPPOE is enabled enter the User Name
• Password: Enter the Password for PPPOE
• Click Apply to save the PPPOE settings.
NTP:
• Enable NTP: Click to Enable the NTP.
• Interval (min): Set the time interval in minutes between the two synchronizing actions
with NTP server.
• NTP Server: Enter the location of the NTP Server
• NTP Port: Enter the port number for the NTP to communicate through.
• Click Apply to save the settings.
Email:
The system can be configured to send an Email notification to all designated users if
an even is detected (an alarm or motion even is detected). Before configuring the Email
setting the DVR must be connected to a local area network (LAN) that maintains an SMTP
mail server. The network must also be connected to either an intranet or the Internet
depending on the location of the e-mail accounts to which the notifications are to be sent.
Additionally, the Preferred DNS Server must be configured. This is found and configured
under the TCP/IP tab.
Page 15
Veo17
Rev.
170119
Advertisement
Table of Contents
