Table of Contents
Advertisement
Wiring plan, connecting
the synchrinising input
(see also "Application
example")
Be careful the polarity of
the cables
18
5.2. Connecting the synchronising input
A DT9100 B synchronising input is a digital input for driving
it either with a contact or with a solid state switch. You may
connect an instrument to the input which output is in
comformity with the following input paremeters:
Uo < 30 V, Io < 200 mA, Po < 0,75 W.
The following figure shows the connection:
1. Push the cable-end until it possible into the terminal
assembly. By pushing the wire in, the self-closing
connection is being established.
2. Check it by pulling it outwards slightly.
DT9100 B
20140130-V0
Advertisement
Table of Contents
