Table of Contents
Advertisement
Mounting positions
Mounting cable entries
10
4. Mounting
4.1. General instructions
Use the enclosed seal when mounting DT9100 B on panel
to assure IP 65 protection between the instrument and the
panel from the front side (only panel mounting version).
Electrostatic hazard! Clean only a moist cloth and
detergent.
Select a mounting position you can easily read the display
reach for mounting and connecting the instrument and that
minimises the hazard of water, dust or dump getting into the
instrument.
The insrument is equipped with one PG11 cable entry and
two additional hole equipped with sealing plugs. Two PG11
cable entry is accessory. If required more than one cable
entry (see chapter 5.) put out the sealing plug turning it in
anticlockwise direction. To put in the cable entry use the
sealing turn it in clockwise direction. Tighten the screws so
much that ensures the desired sealing. Use only appropriet
tools.
DT9100 B
20140130-V0
Advertisement
Table of Contents
