Table of Contents
Advertisement
Wiring plan, connecting
the battery pack
Be careful the polarity of
the cables
Checking the
connections
20
5.4. Connecting the battery pack
The DT9100 B is powered by the built in DT4V5BAT type
intrinsically safe replaceable battery pack, which is not
connected to the clock when shipping. Before using the
battery pack should connect to the clock.
The battery connection or replacement can be accomplish
even in the hasardous area.
Do not use other battery type!
The following figure shows the connection:
1. Push the cable-end until it possible into the terminal
assembly. By pushing the wire in, the self-closing
connection is being established.
2. Check it by pulling it outwards slightly.
Check if the cables are connected properly (have you
connected all the cables, have you connected to the right
place, do not the cable-ends touch each other).
DT9100 B
20140130-V0
Advertisement
Table of Contents
