Table of Contents
Advertisement
Function
Sequence of operations 1. Enter the menu by typing the supervisor code.
Exit from the menu item 1. After finishing the setting, press the MENU button, to exit
Exit from the menu
36
Synchronisation time
7.7.
Setting remote synchronisation time. When in
menu item
The way the code should be type in is described in Chapter
7.1. Typing the code (password) in. You see on the
display:
.
2. Keep stepping by pressing the ▲ button as long as you
see this menu item:
3. Enter the menu item by pressing the ENTER button.
4. You see the actual synchronisation time on the display.
5. Pressing the ▲ button you can increase the value of the
blinking digit:
,
,
,
,
•
Pressing the ► button you can select the next digit, so
you can set all the four digits. (after digit 4 comes digit 1)..
from the menu item, and you see this:
(2. If you want to change the setting you have done just
now, or if you just want to check what you have typed in, go
on with the operation from point 3 of the Sequence of
operations.)
(3. If you don't want to exit the menu, as you want to do
further settings, then you may select the desired menu
items by pressing the ▲ button.)
1. Press the MENU button. First the mnemonic
(Save), then the mnemonic
display. With this the storing of the settings is completed.
The instrument has exited the menu and goes on with the
measurement.
(05. menu item)
is selected the clock will set at this time.
.
,
,
,
,
,
DT9100 B
, etc.
.
(Exit) are shown on the
20140130-V0
Advertisement
Table of Contents
