Table of Contents
Advertisement
DT9100 I4
Connecting as end
device
Wiring plan, connecting
into the current loop
(synchrinising input)
(see also "Application
example")
Be careful the polarity of
the cables
20180905-V1
5.3. Connecting into the current loop (synchronising
input)
The DT9100 I4 acts as a terminal device of the current loop.
In this case the signal comes via a pair of wires, and it does
not have to go to other devices.
The following figure shows the connection:
1. Push the cable-end until it possible into the terminal
assembly. By pushing the wire in, the self-closing
connection is being established.
2. Check it by pulling it outwards slightly.
21
Advertisement
Table of Contents
