Table of Contents
Advertisement
DT9100 B
Function
Sequence of operations 1. Enter the menu by typing the supervisor code.
Exit from the menu item 1. After finishing the setting, press the MENU button to exit
Exit from the menu
20140130-V0
Synchronisation mode
7.6.
Setting the remote synchrinisation mode.
The way the code should be type in is described in Chapter
7.1. Typing the code (password) in. You see this on the
display:
.
2. Keep stepping by pressing the ▲ button as long as you
see this menu item:
3. Enter the menu item by pressing the ENTER button.
4. You see the actual synchronization mode on the display.
The mnemonic is blinking.
5. You can change the synchronisation mode by pressing
the ▲ button.
•
= no remote synchronisation [factory setting]
•
= synchronisation of seconds.
•
= synchronisation at the time given in
menu item.
from the menu item, and you see this:
(2. If you want to change the setting you have done just
now, or if you just want to check what you have typed in, go
on with the operation from point 3 of the Sequence of
operations.)
(3. If you don't want to exit the menu, as you want to do
further settings, then you may select the desired menu
items by pressing the ▲ button.)
1. Press the MENU button. First the mnemonic
(Save), then the mnemonic
display. With this the storing of the settings is completed.
The instrument has exited the menu and goes on with the
measurement.
(04. menu item)
.
(Exit) are shown on the
.
35
Advertisement
Table of Contents
