Table of Contents
Advertisement
DT9102 B
Wiring plan, connecting
the synchrinising input
(see also "Application
example")
Be careful with the polarity
of the cables
20180905-V1
5.2. Connecting the synchronising input
A DT9102 B synchronising input is a digital input for driving
it either with a contact or with a solid state switch. You may
connect an instrument to the input if its output is in
conformity with the following input parameters:
Uo < 30 V, Io < 200 mA, Po < 0.75 W.
The following figure shows the connection:
1. Push the cable end into the terminal assembly as far as
possible. By pushing the wire in, the self-closing connection
is being established.
2. Check it by pulling it outwards slightly.
17
Advertisement
Table of Contents
