Table of Contents
Advertisement
[4.5-2] Setting the communications parameters for the direct-connect
interface
SET CONNECTOR
1:PARAMETER
2:PROTOCOL
(1) Communications parameters setting screen
SET PARAMETER
< CONNECTOR >
1:TRANSMIT SPEED:
300 600 1200 2400
4800
9600
19200
38400 57600 115200
2:PARITY BIT :
N
3:DATA:7
8 4:STOP:1
* For BHT-7000s having a 26-key pad, use F5 , F6 , F7 and F8 keys instead of
, and
keys, respectively
Selecting "2:CONNECTOR" on the SET COMMUNI-
CATION menu calls up the screen shown at left.
1 PARAMETER:
2 PROTOCOL:
Select a desired screen by using the numerical
keys or
ENT key.
To return to the SET COMMUNICATION menu,
press the C key.
Selecting "1:PARAMETER" on the SET CONNEC-
TOR screen calls up the screen shown at left.
Highlighted is the current setting.
1 TRANSMIT SPEED: Sets the transmission
O E
2
2 PARITY BIT:
3 DATA:
4 STOP:
Select a desired item by using the numerical keys
or
* and
ting by using the
To return to the SET CONNECTOR screen, press
the C key.
Switches to the commu-
nications parameters set-
ting screen.
Switches to the commu-
nications protocol screen.
* and
* keys, and then press the
speed.
Sets the vertical parity:
none, odd, or even.
Sets the character length.
Sets the stop bit length.
* keys. Then select a desired set-
* and
If the BHT-Ir protocol has been selected, the
parity bit, character length, and stop bit length
settings will be ignored.
54
* keys.
,
,
Advertisement
Chapters
Table of Contents
