Preparation; Setting-Up 1: Loading The Battery Cartridge - Denso BHT-7000 User Manual

2.4 Preparation

2.4.1 Setting-up 1: Loading the Battery Cartridge

Before the first use of the BHT, be sure to load the battery cartridge as shown below.
The battery cartridge is not loaded in the BHT when shipped from the factory.
(1) To use the rechargeable battery cartridge, charge it. (Refer to Chapter 5, Section
5.5.)
To use the dry battery cartridge, set two dry batteries into the cartridge. (Refer to
the "Dry Battery Cartridge User's Manual" that comes with the dry battery car-
tridge.)
(2) Turn the BHT-7000 upside down.
(3) As shown below, slide the battery cartridge into the BHT until it clicks into place.
(To remove it, press the release button.)
WARNING
CAUTION
Release button
• Never disassemble or heat the battery cartridge,
nor put it into fire or water; doing so could
cause battery-rupture or leakage of battery fluid,
resulting in a fire or bodily injury.
• Do not carry or store the battery cartridge to-
gether with metallic ball-point pens, necklaces,
coins, hairpins, etc.
Doing so could short-circuit the terminal pins,
causing the batteries to rupture or the battery
fluid to leak, resulting in a fire or bodily injury.
• Avoid dropping the battery cartridge or letting
it undergo any shock or impact.
Doing so could cause the batteries to break,
generate heat, rupture or burn.
• Never charge the battery cartridge where any
inflammable gases may be emitted; doing so
could cause fire.
• Do not use batteries or power sources other
than the specified ones; doing so could gener-
ate heat or cause malfunction.
18
Battery cartridge