Bht Preparation" Procedure; Inserting And Charging The Battery Cartridge - Denso BHT-805B User Manual

BHT-805B

2.1 "BHT Preparation" Procedure

Follow the steps below to prepare the BHT for use.
2.2 Inserting and Charging the Battery
Cartridge(Page 14)
2.3 Wearing the Hand Strap
(Page 21)
2.4 Initial Setup
(Page 22)

2.2 Inserting and Charging the Battery Cartridge

The battery cartridge is not charged when purchased and should therefore be charged prior to use.
The chargers that can be use with the BHT are the communication units (CU-801, CU-811 and CU-821) and battery
chargers (CH-201A, CH-851, CH-704 and CH-854).
* The CH-201A and CH-704 are chargers to separately charge the battery cartridge on its own, while the
CH-851 and CH-854 are stationary model (same type as CU (communication unit)) for directly charging
the battery cartridge placed in the BHT.
The charging time is approximately 3 hours.
• The charging time is approximately 7 hours using the CU-821 with power supplied via the USB port.
• This time will be reduced for a battery cartridge with low discharge capacity.
Charging Precautions
• Do not touch any terminal of BHT, battery, or charger by hand or stain them. Doing so could result
in a contact failure or prevent charging.
• Never charge the battery near fire or in a high-temperature environment.
High-temperatures may activate the charger's protective device, preventing from charging, and lead
to protective device damage, overheating, blowout or combustion.
• Terminate charging if not completed even after the specified time has elapsed.
• Do not use battery cartridges other than that specified by DENSO WAVE.
12
First insert and charge the battery cartridge.
Wear the hand strap at your wrist to prevent the BHT
from being dropped.
Set the calendar clock when the power is turned ON for
the first time.