Access Via The Serial Interface - Funkwerk W1002 User Manual

4 Access and Configuration
54
(1) Enter
The login prompt window appears. This is located in the SNMP shell of the device.
(2) Continue with Logging in
Windows
(1) How an SSH connection is set up very much depends on the software used. Consult
the documentation for the program you are using.
As soon as you have connected to the device, the login prompt window will appear.
You are now in the SNMP shell of your gateway.
(2) Continue with Logging in
Note
PuTTY requires certain settings for a connection to a funkwerk device. The support
pages of http://www.funkwerk-ec.com

4.1.2 Access via the Serial Interface

Your device has a serial interface, with which a PC can be connected directly. The follow-
ing chapter describes what you have to remember when setting up a serial connection and
what you can do to configure your device in this way.
Access via the serial interface is ideal if you are setting up an initial configuration of your
device and a LAN access is not possible via the pre-configured IP address
(192.168.0.252/255.255.255.0).
Windows
To connect your device to your PC via the serial interface, proceed as described in
Install Guide on page 7.
If you are using a Windows PC, you need a terminal program for the serial connection, e.g.
HyperTerminal. Make sure that HyperTerminal was also installed on the PC with the Win-
dows installation. However, you can also use any other terminal program that can be set to
the corresponding parameters (see below).
Proceed as follows to access your device via the serial interface:
(1) Click on Programs -> Accessories -> HyperTerminal in the Windows Start menu.
(2) Press Return (at least once) after the HyperTerminal window opens.
A window with the login prompt appears. You are now in the SNMP shell of your device.
You can now log in on your device and start the configuration.
Funkwerk Enterprise Communications GmbH
in a terminal.
on page 55.
on page 55.
include FAQs, which list the required settings.
funkwerk W1002/W2002/WIx040/WIx065
Quick