User Names And Passwords In Ex Works State; Logging In For Configuration - Funkwerk W1002 User Manual

4 Access and Configuration
56
any information on the device or change the configuration without authentication.

4.2.1 User names and passwords in ex works state

In its ex works state, your device is provided with the following user names and passwords:
User names and passwords in ex works state
User name Password
It is only possible to change and save configurations if you log in with the user name
. Access information (user names and passwords) can also only be changed if you log
in with the user name
Setup Tool screen not in plain text, but only as asterisks. The user names, on the other
hand, are displayed as plain text.
The security concept of your device enables you to read all the other configuration settings
with the user name , but not the access information. It is therefore impossible to log in
with , read the password of the
make changes to the configuration.
Caution
All funkwerk devices are shipped with the same user name and password. As long as
the password remains unchanged, the devices are not protected against unauthorised
use. How to change the passwords is described in
.
Make sure you change the passwords to prevent unauthorised access to your device
If you have forgotten your password, you must reset your device to the ex works state,
which means your configuration will be lost.

4.2.2 Logging in for Configuration

Set up a connection to the device. The access options are described in
page 51.
Funkwerk Enterprise Communications GmbH
Authorisations
Read and change system variables, store configurations; use
Funkwerk Configuration Interface and Setup Tool.
Read and write system variables (except passwords) (changes
are lost when you switch off your device).
Read system variables (except passwords).
. For security reasons, passwords are normally shown on the
user and subsequently log in with
Changing the Password on page 74
Access Options
funkwerk W1002/W2002/WIx040/WIx065
and
on