Logging In - Funkwerk W1002 User Manual

Funkwerk Enterprise Communications GmbH
funkwerk W1002/W2002/WIx040/WIx065
Check
If the login prompt does not appear after you press Return several times, the connection to
your device has not been set up successfully.
Therefore, check the COM1 or COM2 settings on your PC.
(1) Click on File ->Properties.
(2) Click Configure in the Connect to tab.
The following settings are necessary:
- Bits per second:
- Data bits:
- Parity:
- Stopbits:
- Flow control:
(3) Enter the values and click OK.
(4) Make the following settings in the Settings tab:
- Emulation:
(5) Click OK.
The changes to the terminal program settings do not take effect until you disconnect the
connection to your device and then make the connection again.
If you use HyperTerminal, there may be problems with displaying umlauts and other special
characters. If necessary, therefore, set HyperTerminal to
.
Unix
You will require a terminal program such as
(on Linux). The settings for these programs correspond to those listed above.
Example of a command line for using
Example of a command line for using

4.2 Logging in

With the help of certain access data, you can log in on your device and carry out different
actions. The extent of the actions available depend on the authorisations of the user con-
cerned.
A login prompt appears first, regardless of how you access your device. You cannot view
(on System V),
:
:
4 Access and Configuration
instead of
(on BSD) or
55