Number Plate Light; Tail Light; Stop Light And Turn Signal Light - Malaguti CENTRO SO 4T Service Manual

50 cc - 4 T
• Disconnect the connector
(C).
• Remove the parabolic spring
carefully.
F. 29

NUMBER PLATE LIGHT

Light bulb 12V - 5W (W5W)
To check that a light bulb (C ) is properly
functioning, position the light switch,
which is located on the right control panel,
in the center position and turn the key to
the starting position.
C
C
F. 30

Tail light

• Take out the lamp holder from inside the headlight.
• Replace the light bulb.
• Reposition the rubber lamp holder (pressure) and remount the cover.

Stop light and turn signal light

• Remove the coloured hood that is held by two hooks.
• Replace the light bulb.
• Reposition the coloured hood and remount the cover.
When performing the operations described above, be very careful to not
damage the near by parts (transmission, cables, gaskets, etc.).
Light bulb replacement
• Remove the number plate light (F),
unscrew the screws (V).
• Remove the rubber lamp holder from the
plastic cover.
• Replace the light bulb.
• Reposition the lamp holder and remount
the cover.
When performing the operations
described above, be very careful
not to damage the near by parts
(transmission, cables, gaskets,
etc.).
20 07/08
F. 31
F
V