Battery; Fitting Battery; Pre-Delivery Operation - Malaguti CENTRO SO 4T Service Manual

50 cc - 4 T
BATTERY (12V - 9Ah)
The battery compartment is located in the front section of
the vehicle.
FITTING BATTERY (pre-delivery operation)
To fit battery, proceed as follows:
• Take a charged battery.
• Remove the 10A general protection fuse.
• Loosen (V4) and remove the front guard (A).
• Loosen the four screws (V) and remove the cover of battery
case (B).
• Insert the battery (C) and make sure it is correctly seated.
• Connect the battery wiring:
- positive pole (+) RED + RED/BLUE cables
- negative pole (-) to the BLACK cables.
• Wrench down the battery terminals.
• Refit the 10A general protection fuse previously removed.
• Check that the battery and the wiring harness are correctly
installed.
• Refit the cover of battery case and the front guard.
NEVER invert the cable connections.
Do not use the battery without the battery inserted and
connected to wires of the main harness. This could
cause breakdowns and short circuits in the electrical
system and components.
It is advisable to use gloves and protective eyewear,
when the battery must be removed from its housing; for
example, when it needs to be recharged.
V
4
F. 33
F. 35
22 07/08
C
A
F. 34
B
V
C
F. 36