Sequence Of Front Wheel Reassembly; Front Brake Caliper - Malaguti CENTRO SO 4T Service Manual

50 cc - 4 T

SEQUENCE OF FRONT WHEEL REASSEMBLY

• Spacer (A)
• Odometer transmission (B)
• Washer (R )
• Wheel pin (P)
• Spacer (C)
• Shim (A1)
• Wheel pin (D)

FRONT BRAKE CALIPER

• Place an appropriate drain pan under the brake calliper.
• Unscrew the hydraulic fitting (A).
Empty the hydraulic circuit completely, pouring the fluid in a special container for
proper disposal in accordance with specific waste disposal laws.
• V2.
• Remove the calliper.
Hydraulic oil is corrosive and may cause personal injury.
Remove the calliper, taking care that fluid line does not get damaged and
the disc and pads do not get dirty. At the end of removal and replacement
operations, check that there are no losses, dry up any traces of fluid and
bleed the system as indicated in page 14.
During reassembly, change the gaskets (G).
V
2
30 ± 20%
D
53 ± 10%
A
20 ± 20%
P
R
B
A
F. 106
V
2
F. 107
43 07/08
C A D
1
G
A
V
2
A