Bleed Brake System; Check Front Brake Pads And Disk; Replacing Pads; Front Caliper - Malaguti CENTRO SO 4T Service Manual

50 cc - 4 T

BLEED BRAKE SYSTEM

FRONT CALIPER

NOTE - Position the vehicle in a stabile manner and
perfectly on level ground.
• Remove the oil pump reservoir cover (A),
unscrewing the relative screws (V2), in order to be
able to top off the fluid.
• Fill the brake fluid reservoir (B) to the highest level.
• Remove the rubber hood (C) of the bleeder screw
(V) and insert a rubber tube to recover the brake
fluid.
• Pump the right brake lever (D), prime it and bring
the system in pressure.
• Keeping the brake lever pumped, loosen the bleeder
screws (V), to allow air to escape. Then, tighten
the bleeder screw (V)
V
12 ± 16%
CHECK FRONT BRAKE
PADS AND DISK
• Check the condition of front brake
pads and disc every 2,000 Km.
• Carry out a visual check on the
thickness of the brake pads.
The minimum thickness of the brake
pad friction material must not be less
than 2mm.
• Replace the pads if they are close to the allowed limit, or if they are damaged.
A
D
F. 12
F. 14
V
2
B
F. 13

REPLACING PADS

NOTE - The procedures for replacing front brake pads can be deduced
from the illustration shown below.
F. 15
14 07/08
C
V