Inolab pH level 2 Instruction Manual page 38

Switching off the
AutoStore
5 As soon as all 800 memory locations are full, the
AutoStore function is terminated (Int 1 = OFF).
If too few storage locations are available for your
measurements:
– backup the data storage (see page 108) and
– clear the data stored (see page 111).
6 Confirm with
The prompt for the I.D. number appears on the dis-
play.
u d
7 Press
8 Confirm with
The instrument changes to the pH measuring mode
and starts the measuring and storage procedure.
AutoStore flashes on the display.
Note
The AutoStore function is interrupted if you perform other
functions, e.g. output data storage.
After completing the other function, the AutoStore function
continues. However, as a result, gaps can occur in the
recording of the measured values.
Switch off the AutoStore function by:
l Setting the storage interval (Int 1) to OFF or
l Switch the pH meter off and on again.
g
.
to set the required I.D. number
g
.
Operation
107