Camera Bench Test; Log In To The Camera Web Page - FLIR FB-Series O User And Installation Manual

2 Basic Operation and Configuration
2.3
The camera offers both analog video and IP video, and since the camera can be powered by PoE or
by a conventional power supply, there are several ways to bench test the camera. It is recommended
that the installer test the camera using the same type of connections as in the final installation.
Even if using analog video and conventional power in the final installation, it is a good idea to test the
IP communications when performing the bench test. If any image adjustments are necessary, they
can be done using a web browser over the IP connection, and saved as power-on default settings.
Note
About 20 seconds after the camera is powered on, analog video starts and the camera's IP address
is shown on the display for about 30 seconds.
With the camera powered up, analog video can be tested at the BNC connector. Connect the camera
to a video monitor and confirm the live video is displayed on the monitor.
If using a conventional power supply, connect the camera to a network switch with an Ethernet cable,
and connect a PC or laptop to the switch also. Use a web browser to access and test the camera as
described below, and if necessary make configuration changes prior to installation.
2.3.1
With a web browser, log in to the camera using one of three User Names: user, expert, and admin.
By default, the passwords are: user, expert, and admin, respectively. The login passwords should
be changed to prevent unauthorized access (refer to
Open a web browser and enter the camera's IP address. The login screen with a picture of the
camera will appear. A pull-down list in the upper right allows the user to select a language option.
Enter user for the User Name and user for the Password, and click Log in.
427-0064-00-12 Version 100

Camera Bench Test

Log in to the Camera Web Page

Figure 2-1: Camera Web Page Login Screen
Basic Camera Configuration, pg.
August 2017
18).
15