Configuring Ipv6 Vrrp; Ipv6 Vrrp Configuration Task List; Specifying An Ipv6 Vrrp Operating Mode - HP VSR1000 High Availability Configuration Manual

Task
Clear statistics for IPv4 VRRP
groups.

Configuring IPv6 VRRP

This section describes how to configure IPv6 VRRP.

IPv6 VRRP configuration task list

Tasks at a glance
(Required.)
mode
(Required.)
assigning a virtual IPv6 address
(Optional.)
preemptive mode, and tracking function
(Optional.)
(Optional.)
attributes
(Optional.)

Specifying an IPv6 VRRP operating mode

A VRRP group can operate in either of the following modes:
• Standard mode—Only the master can forward packets.
Load balancing mode—All members that have an AVF can forward packets.
•
After the IPv6 VRRP operating mode is specified on a router, all IPv6 VRRP groups on the router operate
in the specified operating mode.
To specify an IPv6 VRRP operating mode:
Step
1. Enter system view.
2. Specify an IPv6 VRRP
operating mode.
Specifying an IPv6 VRRP operating
Creating a VRRP group and
Configuring the router priority,
Configuring VF tracking
Configuring IPv6 VRRP packet
Disabling an IPv6 VRRP group
Command
system-view
•
•
Command
reset vrrp statistics [ interface interface-type interface-number [ vrid
virtual-router-id ] ]
Remarks
N/A
N/A
N/A
This configuration applies to only VRRP load balancing
mode.
N/A
N/A
Specify the standard mode:
undo vrrp ipv6 mode
Specify the load balancing
mode:
vrrp ipv6 mode load-balance
16
Remarks
N/A
Use one of the commands.
By default, VRRP operates in
standard mode.