Static Routing-Track-Nqa Collaboration Configuration Example - HP VSR1000 High Availability Configuration Manual

Virtual services router
Table of Contents

Advertisement

Running Mode
Total number of virtual routers : 1
Interface GigabitEthernet2/0
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
The output shows that when Router A detects that the uplink fails through BFD, it decreases its priority by
20 to make sure that Router B can preempt as the master.

Static routing-Track-NQA collaboration configuration example

Network requirements
As shown in
20.1.1.0/24 and 30.1.1.0/24. Configure static routes on these routers so that the two segments can
communicate with each other. Configure route backup to improve network reliability.
Router A is the default gateway of the hosts in segment 20.1.1.0/24. Two static routes to 30.1.1.0/24 exist
on Router A, with the next hop being Router B and Router C, respectively. These two static routes back up
each other, as follows:
The static route with Router B as the next hop has a higher priority, and is the master route. If this
route is available, Router A forwards packets to 30.1.1.0/24 through Router B.
The static route with Router C as the next hop acts as the backup route.
Configure static routing-Track-NQA collaboration to determine whether the master route is
available in real time. If the master route is unavailable, the backup route takes effect, and Router
A forwards packets to 30.1.1.0/24 through Router C.
Similarly, Router D is the default gateway of the hosts in segment 30.1.1.0/24. Two static routes to
20.1.1.0/24 exist on Router D, with the next hop being Router B and Router C, respectively. These two
static routes back up each other, as follows:
The static route with Router B as the next hop has a higher priority, and is the master route. If this
route is available, Router D forwards packets to 20.1.1.0/24 through Router B.
The static route with Router C as the next hop acts as the backup route.
Configure static routing-Track-NQA collaboration to determine whether the master route is
available in real time. If the master route is unavailable, the backup route takes effect, and Router
D forwards packets to 20.1.1.0/24 through Router C.
: Standard
: 1
: Up
: 100
: Yes
: None
: 192.168.0.10
: 0000-5e00-0101
: 192.168.0.102
Figure
19, Router A, Router B, Router C, and Router D are connected to two segments
Adver Timer
: 100
State
: Master
Running Pri
: 100
Delay Time
: 0
72

Advertisement

Table of Contents
loading

This manual is also suitable for:

Msr3000 seriesMsr4000 seriesMsr2000 series

Table of Contents