HP VSR1000 High Availability Configuration Manual page 28

[RouterA] interface gigabitethernet 1/0
[RouterA-GigabitEthernet1/0] ip address 10.1.1.1 255.255.255.0
# Create VRRP group 1 and set its virtual IP address to 10.1.1.111.
[RouterA-GigabitEthernet1/0] vrrp vrid 1 virtual-ip 10.1.1.111
# Assign Router A a higher priority than Router B in VRRP group 1, so Router A can become the
master in the group.
[RouterA-GigabitEthernet1/0] vrrp vrid 1 priority 110
# Create VRRP group 2, and set its virtual IP address to 10.1.1.112.
[RouterA-GigabitEthernet1/0] vrrp vrid 2 virtual-ip 10.1.1.112
2. Configure Router B:
# Specify an IP address for Router B.
<RouterB> system-view
[RouterB] interface gigabitethernet 1/0
[RouterB-GigabitEthernet1/0] ip address 10.1.1.2 255.255.255.0
# Create VRRP group 1, and set its virtual IP address to 10.1.1.111.
[RouterB-GigabitEthernet1/0] vrrp vrid 1 virtual-ip 10.1.1.111
# Create VRRP group 2, and set its virtual IP address to 10.1.1.112.
[RouterB-GigabitEthernet1/0] vrrp vrid 2 virtual-ip 10.1.1.112
# Assign Router B a higher priority than Router A in VRRP group 2, so Router B can become the
master in the group.
[RouterB-GigabitEthernet1/0] vrrp vrid 2 priority 110
3. Verify the configuration:
# Display detailed information about the VRRP groups on Router A.
[RouterA-GigabitEthernet1/0] display vrrp verbose
IPv4 Virtual Router Information:
Running Mode
Total number of virtual routers : 2
Interface GigabitEthernet1/0
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
Interface GigabitEthernet1/0
VRID
Admin Status
Config Pri
Preempt Mode
Become Master
Auth Type
Virtual IP
Master IP
: Standard
: 1
: Up
: 110
: Yes
: None
: 10.1.1.111
: 0000-5e00-0101
: 10.1.1.1
: 2
: Up
: 100
: Yes
: 201ms left
: None
: 10.1.1.112
: 10.1.1.2
24
Adver Timer : 100
State : Master
Running Pri : 110
Delay Time : 0
Adver Timer : 100
State : Backup
Running Pri : 100
Delay Time : 0