Meru Networks AP332 Installation Manual page 28

Install the AP332e
Use the optional T-bar box hanger mounting kit to mount AP332e above suspended ceiling T-rails. The
installation attaches the T-bar box hanger to the ceiling rails and then the AP332e attaches to the T-
bar box hanger. Note that AP332e mounted above the ceiling has about 2-3 dBm less RF coverage than
AP332e mounted under the ceiling.
You may need to modify thicker tiles to support this installation.
Warning! When installed in air-handling spaces, such as above a suspended ceiling,
power the AP332e only with a PoE, not a power supply.
To mount an AP332e above the ceiling with the optional T-bar kit, follow these steps:
1. Determine the location on the ceiling rails where the AP will be mounted and remove the ceiling
tile.
2. Unpack the T-bar hanger kit.
3. Attach the mounting bar (depicted in
handle) with the crossbar of the mounting kit sandwiched between them. See
Figure 10: Mounting Bar
16 Meru Access Point Installation Guide
Figure 10) to the mounting brace (which looks like a small
Figure 11.
© 2012 Meru Networks, Inc.