Emerson Rosemount 5400 Series Reference Manual page 102

Rosemount 5400 Series
Message
Add item for ALL device types or
only for this ONE device type.
Command Not Implemented
Communication Error
Configuration memory not
compatible with connected
device
Device Busy
Device Disconnected
Device write protected
Device write protected.
Do you still want to shut off?
Display value of variable on
hotkey menu?
Download data from
configuration memory to device
Exceed field width
Exceed precision
Field device has malfunctioned
due to a Hardware Error or
Failure
Ignore next 50 occurrences
of status?
Illegal character
Illegal date
Illegal month
Illegal year
Incomplete exponent
Incomplete field
Looking for a device
Mark as read only variable on
hotkey menu?
No device configuration in
configuration memory
No Device Found
No hotkey menu available for
this device.
No offline devices available.
No simulation devices available.
No UPLOAD_VARIABLES in ddl
for this device
No Valid Items
OFF KEY DISABLED
Online device disconnected with
unsent data. RETRY or OK to
lose data.
Out of memory for hotkey
configuration. Delete
unnecessary items.
C-10
Table C-2. HART Communicator Diagnostic Messages
Description
Asks the user whether the hot key item being added should be added for all device types or only for
the type of device that is connected.
The connected device does not support this function.
Either a device sends back a response indicating that the message it received was unintelligible, or
the HC cannot understand the response from the device.
The configuration stored in memory is incompatible with the device to which a transfer has been
requested.
The connected device is busy performing another task.
Device fails to respond to a command.
Device is in write-protect mode. Data can not be written.
Device is in write-protect mode. Press YES to turn the HC off and lose the unsent data.
Asks whether the value of the variable should be displayed adjacent to its label on the hotkey menu if
the item being added to the hotkey menu is a variable.
Prompts user to press SEND softkey to initiate a memory to device transfer.
Indicates that the field width for the current arithmetic variable exceeds the device-specified
description edit format.
Indicates that the precision for the current arithmetic variable exceeds the device-specified
description edit format.
The 3300 transmitter may simply be configured incorrectly (20 mA point in upper Null Zone, etc.)
Verify the configuration.
Asked after displaying device status. Softkey answer determines whether next 50 occurrences of
device status will be ignored or displayed.
An invalid character for the variable type was entered.
The day portion of the date is invalid.
The month portion of the date is invalid.
The year portion of the date is invalid.
The exponent of a scientific notation floating point variable is incomplete.
The value entered is not complete for the variable type.
Polling for multidropped devices at addresses 1–15.
Asks whether the user should be allowed to edit the variable from the hotkey menu if the item being
added to the hotkey menu is a variable.
There is no configuration saved in memory available to re-configure offline or transfer to a device.
Poll of address zero fails to find a device, or poll of all addresses fails to find a device if auto-poll is
enabled.
There is no menu named "hotkey" defined in the device description for this device.
There are no device descriptions available to be used to configure a device offline.
There are no device descriptions available to simulate a device.
There is no menu named "upload_variables" defined in the device description for this device. This
menu is required for offline configuration.
The selected menu or edit display contains no valid items.
Appears when the user attempts to turn the HC off before sending modified data or before
completing a method.
There is unsent data for a previously connected device. Press RETRY to send data, or press OK to
disconnect and lose unsent data.
There is no more memory available to store additional hotkey items. Unnecessary items should be
deleted to make space available.
Reference Manual
00809-0100-xx, Rev AA
November 2003