Figure 46: Pair With a Radio Screen
3 Place the radio close to the LEX L10, aligning the blue pairing point on the LEX L10 with the blue pairing point
on the radio.
Note: The blue pairing points must be within 2.5 cm of each other for pairing to happen.
Figure 47: Blue Pairing Dots
•
If the pairing process is successful, the radio sounds an incremental-pitched tone to indicate paired.
•
If the pairing process fails, the radio sounds a short, low pitched tone. On the LEX L10 screen, tap Tap Pair to
try again to resume pairing.
Once a successful pairing is established, the Bluetooth Connection screen is displayed for a few seconds,
followed by the Radio Remote Control screen.
Radio Remote Control | 81
MN001456A01-A | February 2015 |
Send Feedback