Cleaning The Lex L10; Cleaning The Interface Connector; Cleaning The Battery Contacts - Motorola LEX L10 Manual

10.4 Cleaning the LEX L10

Housing
Using the alcohol wipes, wipe the housing including buttons.
Display
The display can be wiped down with the alcohol wipes, but care should be taken not to allow any pooling of liquid
around the edges of the display. Immediately dry the display with a soft, non-abrasive cloth to prevent streaking.
Camera Window
Wipe the camera window periodically with a lens tissue or other material suitable for cleaning optical material such
as eyeglasses.

10.5 Cleaning the Interface Connector

To clean the contacts of the interface connector on LEX L10:
Procedure:
1 Power off the LEX L10.
OPTIONAL TAG: Type additional step information here e.g. notes - or delete this tag
2 Dip the cotton portion of the cotton-tipped applicator in isopropyl alcohol.
3 Rub the cotton portion of the cotton-tipped applicator along the contacts of the interface connector. Slowly move
the applicator back-and-forth from one side of the connector to the other.
4 If grease and other dirt can be found on other areas of the cradle, remove using a lint-free cloth and alcohol.
5 Allow few minutes (depending on ambient temperature and humidity) for the alcohol to air dry before powering
on the LEX L10.

10.6 Cleaning the Battery Contacts

To clean the connectors:
Procedure:
1 Remove the main battery from LEX L10.
2 Dip the cotton portion of the cotton-tipped applicator in isopropyl alcohol.
3 Gently, rub the cotton portion of the cotton-tipped applicator back-and-forth across the contacts. Do not leave any
cotton residue on the contacts.
4 Use the cotton-tipped applicator dipped in alcohol to remove any grease and dirt near the contacts area.
5 Use a dry cotton-tipped applicator and repeat steps 4 and 5 at least three times.
Caution: Do not point nozzle at yourself and others. Ensure that the nozzle or tube is away from your
face.
6 Spray compressed air on the connector area by pointing the tube/nozzle about ½ inch away from the surface.
7 Inspect the area for any grease or dirt, repeat if required.
Maintenance & Troubleshooting | 147
MN001456A01-A | February 2015 | Send Feedback