Service Schedule [see Service Schedule (4.7.) on page 111]
•
Service Interval
•
Time since last Service
•
Time until next Service
•
Activation of Reminders
•
Reminder 1 before Service (Required)
•
Reminder 2 before Service (Demanded)
•
Click on Service Performed to reset Time Until Next Service to the full service
interval.
Calibration Schedule [see Calibration Schedule (4.8.) on page 114]
•
Calibration Interval
•
Time since last Calibration
•
Time Until Next Calibration
•
Activation of Reminders
•
Reminder 1 before Calibration (Required)
•
Reminder 2 before Calibration (Demanded)
•
Click on Calibration Performed to reset Time Until Next Calibration to the full
calibration interval.
Electronic Temperature
•
Electronic Temperature
•
Lowest Value
•
Highest Value
Wear (see Powered Hours (4.3.) on page 110)
•
Time in Operation (Reset to 0 after clicking Sensor Replaced)
•
Poweron Resets
Communication
Navigate to Communication to read the following:
Long Tag; Manufacturer's ID; Device ID; Product ID; Device Revision; EDD Revision; Universal
Command
Security
Navigate to Configure/Setup > Security to access:
Remote Access [see Remote Lockout (5.2.) on page 117]
Note: If access control is changed via the handheld programmer to limit remote
access, it can only be reset via the handheld programmer. See
on page 117
(5.2.)
•
Write Protection
Local Access
•
Local Operation Enable
Password Protection
See also
A5E34647946
SITRANS LR560 (mA/HART) – OPERATING INSTRUCTIONS
.
on page 75.
Remote Lockout
Page 73