Rear Fan Assembly - Lenovo ThinkServer TS150 User Manual And Hardware Maintenance Manual

6. To install a new front fan assembly, see "Installing the front fan assembly" on page 85.
7. If you are instructed to return the old front fan assembly, follow all packaging instructions and use any
packaging materials that are supplied to you for shipping.
Installing the front fan assembly
To install a new front fan assembly, do the following:
1. Prepare your server. See "Preparing your server and removing the server cover" on page 41.
2. Remove the front bezel. "Removing the front bezel" on page 42.
3. Remove the old front fan assembly in your server. See "Removing the front USB assembly" on page 77.
4. Align the rubber mounts of the new front fan assembly with the corresponding holes in the chassis
and push the rubber mounts through the holes.
5. Carefully pull on the tips of the rubber mounts until the front fan assembly is secured in place.
Figure 77. Installing the front fan assembly
6. Connect the front fan assembly cable to the front system fan connector on the system board. See
"System board components" on page 20.

Rear fan assembly

• "Removing the rear fan assembly" on page 85
• "Installing the rear fan assembly" on page 86
Removing the rear fan assembly
To remove the rear fan assembly, do the following:
1. Prepare your server. See "Preparing your server and removing the server cover" on page 41.
2. Locate the rear fan assembly. See "Server components" on page 17.
3. Disconnect the cable of the rear fan assembly.
.
Chapter 5 Replacing hardware
85