Security Menu; Startup Menu - Lenovo ThinkServer TS150 User Manual And Hardware Maintenance Manual

The Power menu contains the following items.
Menu item
After Power Loss
Enhanced Power Saving Mode
Intelligent Cooling Engine (ICE)
Automatic Power On

Security menu

You can set passwords and configure other security features on the Security menu in the Setup Utility
program. Some items are displayed on the menu only if the server supports the corresponding features.
The Security menu contains the following main items:
Menu item
Administrator Password
Power-On Password
Set Administrator Password
Set Power-On Password
Chassis Intrusion Detection
TCG Feature Setup
System Event Log
Secure Boot

Startup menu

The Startup menu provides an interface for you to view or change the server startup options, including the
startup sequence and boot priority for various devices. Changes to the startup options take effect when
the server restarts. The startup sequence specifies the order in which the server checks devices to find
a boot record. The server starts from the first boot record that it finds. For example, you can define a
startup sequence that checks a disc in the optical drive, then checks the hard disk drive, and then checks
a network device. For information about setting the startup sequence or selecting a startup device, see
"Selecting a startup device" on page 29.
The Startup menu contains various configuration items. Some items are displayed on the menu only if
the server supports the corresponding features.
Menu item
Primary Boot Sequence
Automatic Boot Sequence
Error Boot Sequence
Description
View and configure the system performance after the ac power is interrupted.
Enable or disable Enhanced Power Saving Mode.
Enable the system to enter the lower acoustic level or better thermal level.
Enable or disable the Automatic Power On features.
Description
View the status of an administrator password.
View the status of a user password.
Set an administrator password to protect against unauthorized access to your
server. See "Using passwords" on page 28.
Set a user password to protect against unauthorized access to your server. See
"Using passwords" on page 28.
Enable or disable the Chassis Intrusion Detection feature.
Configure the TPM function. See "Configuring the TPM function" on page 30.
View and clear the system event log.
View and set secure boot parameters.
Description
This sequence is used when the system is powered up normally.
This sequence is used when a communication device wakes up the system.
This sequence is used when an error occurs.
.
Chapter 4 Configuring the server
27