Table of Contents
Advertisement
a. Disconnect the front-fan assembly cable from the power fan connector on the system board. See
"Parts on the system board" on page 6.
b. The front fan assembly is attached to the chassis by four rubber mounts. Break or cut the rubber
mounts and gently pull the front fan assembly out of the chassis.
Figure 94. Removing the front fan assembly
5. To install the front fan assembly, do the following:
a. Align the new rubber mounts of the new front fan assembly with the corresponding holes in the
chassis. Push the rubber mounts through the holes.
b. Pull the tips of the rubber mounts until the front fan assembly is secured in place.
Figure 95. Installing the front fan assembly
c. Connect the front-fan assembly cable to the front-fan connector on the system board. See "Parts on
the system board" on page 6.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 108.
Rear fan assembly
Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page iii.
To remove or install the rear fan assembly, do the following:
106
P520c User Guide
Advertisement
Table of Contents
