Tape Drive - Lenovo ThinkServer TS150 User Manual And Hardware Maintenance Manual

7. Connect cables to the optical drive.
Figure 21. Connecting cables to the optical drive
Cable
1-to-3 power cable
Signal cable
Notes:
• The 1-to-3 power cable provides three SATA power connectors
any one of the SATA connectors to the drive.
• If your server has a secondary optical drive installed, connect the signal cable from the secondary
optical drive to the SATA connector 4 on the system board. See "System board components" on
page 20.

Tape drive

Your server supports an RDX tape drive in drive bay 4. For information about drive bays and installation
rules, see "Internal drives" on page 44.
• "Removing a tape drive" on page 50
• "Installing a tape drive" on page 51
Removing a tape drive
To remove a tape drive, do the following:
1. Prepare your server. See "Preparing your server and removing the server cover" on page 41.
2. Remove the front bezel. See "Removing the front bezel" on page 42.
3. Disconnect the signal cable and power cable from the tape drive.
50
ThinkServer TS150 User Guide and Hardware Maintenance Manual
1
2
From the system board
1 2
or 4-pin power connector
3
SATA connector 5
3
To the optical drive
4
Power connector on the optical drive
5
Signal connector on the optical drive
1 , 2 , and
1
2
3
4 5
3 . You can connect