Expanding The Device And Assigning Device Parameters; Opening The Device; Opening The Built-In Unit - Siemens SIMATIC IPC477E Operating Instructions Manual

Expanding the device and assigning device
parameters
6.1

Opening the device

6.1.1

Opening the built-in unit

The device must be opened in order to install a memory expansion. Read the information in
the section "ESD guideline (Page 114)" when doing this.
Opening device with expansions
To open devices with the PCIe card expansion, you first have to dismantle this expansion.
You can find additional information on this in the following section:
● Installing and removing a PCIe card (built-in units with PCIe card) (Page 83)
Opening device without expansions
For devices without expansions, only the rear panel of the device is removed.
Requirement
● The device is disconnected from the power supply.
● All cables are removed from the device.
● The device is removed.
● T10 screwdriver
SIMATIC IPC477E
Operating Instructions, 12/2016, A5E37455003-AB
6
79