Partitioning In Windows 7 Ultimate; Adapting Partitions In Windows 7 Ultimate And Windows Embedded Standard 7 - Siemens SIMATIC IPC477E Operating Instructions Manual

Maintaining and servicing your device
7.5 Installing the software
7.5.2.2

Partitioning in Windows 7 Ultimate

You will need to reconfigure the partitions after installing a new drive, to repair corrupt
partitions or to change the partitioning.
Partitioning of the HDD or SSD
In the factory state, the following partitions are set up on the HDD or SSD for the
Windows 7 x64 UEFI operating system:
Partition
First
Second
Third
Fourth
7.5.2.3

Adapting partitions in Windows 7 Ultimate and Windows Embedded Standard 7

With the disk management, you can adapt the partitioning of your drives.
You can reduce or delete an available partition to acquire unassigned memory space, which
you can use to set up a new partition or to increase an existing partition.
Note
Data lost in the case of deleting a partition!
If you delete a partition, all the data on this partition is lost.
Back up your data before you change partitions.
Requirement
You are logged on as an administrator.
Procedure - Reduce partition
A partition can only be reduced if sufficient space is available.
1. Click with the right mouse button on the partition to be reduced and click on "Reduce
size".
2. Follow the instructions.
106
Name Partition size
SSD: 80 GB
Boot
MSR
System 60 GB
Data Remainder
SSD/HDD: > 200 GB
260 MB
128 MB
100 GB
Operating Instructions, 12/2016, A5E37455003-AB
File system
FAT32
None
NTFS, not compressed
NTFS, not compressed
SIMATIC IPC477E