Siemens SIMATIC IPC477E Operating Instructions Manual page 37

1.
2.
3.
4.
5.
SIMATIC IPC477E
Operating Instructions, 12/2016, A5E37455003-AB
Working from the front, insert the device
into the mounting cut-out. Secure the
device to prevent it from falling out.
Insert a mounting clip into the cutout
provided on the device. Make sure it is
in the correct position, see the section
"Mounting clips or mounting brackets,
position for IP65-compliant installation
(Page 35)".
Tighten the threaded pin to secure the
mounting clip. The maximum torque
when tightening the threaded pins of the
mounting clips is 0.5 Nm.
Repeat steps 2 and 3 for all mounting
clips.
Check the fit of the mounting seal.
Mounting and connecting the device
3.2 Installing the built-in unit
Mounting clips for devices with 15", 19" or 22"
display
37