NURIT 8400
To connect a USB peripheral device to the NURIT 8400:
1. Disconnect the AC/DC Power Adapter from the electrical
power outlet.
2. Remove the cable connection cover, as described in
"Removing and Replacing the Cable Compartment Cover" on
page 14.
3. Insert the USB plug into the USB connector on the
peripheral device.
4. Insert the USB plug into the USB connector on the
NURIT 8400 terminal.
Figure 12-2 Typical Connection to an ECR
Figure 12-3 Typical USB Connection to a PC-POS
5. Replace the cable connection cover, as described on
page 15.
6. Reconnect the AC/DC Power Adapter to the electrical
power outlet.
Installation Manual
27