Configuring The Ecr (Ms Windows) - VeriFone External P400+ User Manual

External | P400+ User Manual | Version 2.3 | March 22nd, 2021

3.3.2 Configuring the ECR (MS Windows)

To enable the communication of PoS application with the P400+, and to allow the P400+ to
access the Verifone gateway, two sets of configuration needs to be made to the ECR. These
are configuring a network adaptor to support RNDIS and setting the network adaptor
managing WAN connectivity to share the internet connection.
Before plugging in the P400+, The supplied Verifone driver needs to be installed. Verifone
will supply a driver package.
VerifoneUnifiedDriverInstaller-v05.00.05.02-B3 or a later version.
Documentation is supplied with the driver, please ensure this is read, and note taken of any
specific Microsoft or Verifone prerequisites. It is highly recommended for ease of swap out
of the PED that the following flag is used IGNOREHWSERNUM=1' when using the silent
installers. This flag prevents the need to setup the Internet Connection Sharing with a new
device. If the silent installer is not used this setting can be manually changed in the Registry
Editor.
For Windows 10, there is an issue with the Internet connection service not restarting after a
reboot. Please refer to the issue and the resolution:
https://support.microsoft.com/en-gb/help/4055559/ics-doesn-t-work-after-computer-or-
service-restart-on-windows-10
Ensure the Service is set up as follows:
P400+ User Manual
52