Password Setting; Save & Exit Setup; Exit Without Saving - Advantech DSA-3400 User Manual

4.8.4 PCI/VGA Palette Snoop
This is left at "Disabled."

4.9 Password Setting

To change the password:
1. Choose the "Set Password" option from the "Initial Setup Screen" menu and press <Enter>.
The screen will display the following message:
Please Enter Your Password
Press <Enter>.
2. If the CMOS is good or if this option has been used to change the default password, the
user is asked for the password stored in the CMOS. The screen will display the following
message:
Please Confirm Your Password
Enter the current password and press <Enter>.
3. After pressing <Enter> (ROM password) or the current password (user-defined), you can
change the password stored in the CMOS. The password must be no longer than eight (8)
characters.
Remember, to enable the password setting feature, you must first select either "Setup" or
"System" from the "Advanced BIOS Features" menu.
4.10 Save & Exit Setup
If you select this and press <Enter>, the values entered in the setup utilities will be recorded
in the CMOS memory of the chipset. The microprocessor will check this every time you turn
your system on and compare this to what it finds as it checks the system. This record is
required for the system to operate.

4.11 Exit Without Saving

Selecting this option and pressing <Enter> lets you exit the setup program without recording
any new values or changing old ones.