Advantech DSA-3400 User Manual page 49

4.7.3 Video Off In Suspend
When system is in suspend, video will turn off.
4.7.4 Modem Use IRQ
This determines the IRQ in which the MODEM can use.The choices: 3, 4, 5, 7, 9, 10, 11, NA.
4.7.5 HDD Power Down
You can choose to turn the HDD off after one of the time intervals listed, or when the system
is in "suspend" mode. If the HDD is in a power saving mode, any access to it will wake it up.
4.7.6 Soft-Off by PWR-BTTN
If you choose "Instant-Off", then pushing the ATX soft power switch button once will switch
the system to "system off" power mode. You can choose "Delay 4 sec." If you do, then
pushing the button for more than 4 seconds will turn off the system, whereas pushing the
button momentarily (for less than 4 seconds) will switch the system to "suspend" mode.
4.7.7 CPU THRM-Throttling
This field allows you to select the CPU THRM-Throttling rate. The choices: 12.5%, 24.0%,
37.5%, 50.0%, 62.5%, 74.0%, 87.5%.
4.7.8 PowerOn By LAN
This item allows you to wake up the system via LAN from the remote host. The choices:
Enabled, Disabled.
4.7.9 PowerOn By Modem
When Enabled an input signal on the serial Ring Indicator (RI) line (in other words, an
incoming call on the modem) awakens the system from a soft off state. The choices: Enabled,
Disabled.
4.7.10 PowerOn By Alarm
When Enabled, your can set the date and time at which the RTC (real time clock) alarm
awakens the system from Suspend mode. The choices: Enabled, Disabled.
4.7.11 Primary IDE 0 (1) and Secondary IDE 0 (1)
When Enabled, the system will resume from suspend mode if Primary IDE 0 (1) or Secondary
IDE 0 (1) is active. The choice: Enabled, Disabled.
4.7.12 FDD, COM, LPT PORT
When Enabled, the system will resume from suspend mode if FDD, COM port, or LPT port is
active. The choice: Enabled, Disabled.
- 49 -