Setting Of Upper Limit Values; Changes Of Key Lock Mode - SANKO PM-101 Operating Instruction

4-6 Setting of Upper Limit Values

・Press the Upper Limit Value Key「H」⑥ when Power ON is in process.
・A buzzer emits「peep」sounds and the「H」,「●」marks of an upper limit
value indications and「15.0%」of the range of the upper limit are displayed.
・Press and hold a「▼」key ④ until it has reached to a desired upper limit value.
Keeping the「▼」key ④ pressed changes to a fast winding of numerical values.
・Release your finger of the「▼」key ④ when the values has reached to a
desired value.
・When the value has reached too small beyond the desired one, press the「▲」
Key ④ to adjust the value.
・Set an upper limit value by pressing the「H」⑥ key again.
・A buzzer emits a " Peep" sound and the upper limit setting mark「●」is
indicated on the edge of the left side of LCD display ⑦.
＊ An interval between setting values is a 0.5% notch.
＊ " TEMP", "HOLD" is not displayed during in process of setting.
＊ Possible to activate the same operations even at the MC mode.
・At a real time measuring, it sounds a buzzer " Peep, Peep, Peep " when a measuring value exceeds a setting
value, and the upper limit value and the measuring value alternately blinks on the display while being probed
to contact. Releasing the probe turns to「LLL」on display.
・ At a Hold Mode measuring, when it exceeds the setting value and even after releasing the probe off the object,
the upper limit value and the measured value are alternately kept blinking.
・Press a「H」key ⑥ again and repeat the same procedures as before to change upper limit values.
Possible to operate the same procedures during measuring in process (Hold mode or Non-Hold mode).
＊When Upper Limit Value is unnecessary for an initial operation, press again the ｢H｣key after pressing first
the ｢H｣ key. In this case the Upper Limit Value is set at 15%, Maximum.
＊To delete an Upper Limit Value, set the Upper Limit Value at 15 % or switch Power to OFF.
And the Upper Limit Value will also be deleted when Power switches OFF with Auto-Power-Off.
4-7 Changes of Key -Lock Mode
A press of a Lock Key ⑤ locks all the keys except Power SW ① and
prevents erroneous operations. Switch off Power to release.
7
ex) set upper limit value to 12%