How To Operate Probe; Changes Of Hold Mode - SANKO PM-101 Operating Instruction

4-4 How to operate Probe

・ Press the tip of the rubber against a measurement object evenly, squarely and with even power.
・ Make sure that the rubber electrode never be deformed or broken.
・ In case of measuring rough faces of a measurement object, choose a level face for the measurement or
compensate or average a measurement value.
・ Make sure that a probe, contact part(plug, connectors, etc.), electrodes, cords and the like should always be
kept clean and dry.

4-5 Changes of Hold Mode

A press of Hold･Average Key ② turns to the Hold Mode with a「peep」sound.
Each press of the key changes the Hold Mode alternately to ON or OFF and
「Hold」is displayed on LC Display ⑦ when ON is in process. The displayed
measuring value is on hold until a next measuring value has been input.
＊A press of long periods (approx. 1 sec.) turns to Average Value Mode
(temporary memory). To release it, press again and hold the Hold・Average
Key② for long periods (approx. 2 sec.).
6