4. How to use
4-1 Connection or disconnection of probe
(ensure that Power Source of a main body is OFF).
・ Hook up the Probe connector ⑪ to a main body to meet
the Arrow Mark of the Probe Connector ⑪ with the Mark of
Probe Connector Receptacle ⑧ and insert it carefully up to the
end of a stroke.
・ Switch Power OFF to disconnect Probe Connector from the receptacle.
* Unnatural force in inserting and pulling off may cause damages to connectors in a receptacle and a cord.
4-2 POWER ON・OFF
・ Press Power SW ① to emit a" Peep" sound ,and "LLL" and Measuring
Mode"M" marks are displayed ⑦.
・ Press again to switch OFF, emitting a "Peep" sound to turn off the display.
・ Availability of Auto-Power-OFF preventing batteries from being
consumed when Power is forgotten to switch off. An interval of 3 minutes without operation of measuring
will automatically switch off.
* Press Power SW ① to ON or OFF at an interval of 3 to 5 seconds to prevent operating errors.
4-3 Changes of Measuring Mode
・ When Power is ON、 「M」Mortar・Concrete Mode is displayed.
For changes of Measuring Mode, press a Mode-Change「G」key ③ to change the following turns by each
・
press.
When Power is On
Press 「G」key
Returning again to ON from OFF, the mode automatically returns to an initial measuring modes. Confirm
a measuring mode when Power is ON.
「TEMP」 is not displayed with the MC mode of Moisture Content because there is no temperature
compensating with the mode.
Mortar・Concrete
↓
Press 「G」key. Plaster
↓
Press 「G」 key.
MC Mode
Probe connector receptacle
LCD Display
M
↓
P
↓
MC-4
5
Probe connector