Kenmore 664.7512 Use & Care Manual page 22

Problem Possible Causes
Oven burner
Range converted improperly
flames are yellow
or noisy
Oven temperature Oven temperature needs
too high or too low adjustment
Convection fan The convection cycle is in the first
not working 5 minutes of operation
Oven door is open
Display shows Power failure (display shows
messages
flashing time)
Error code (display shows letter
followed by number)
Start needs to be pressed so a cycle
can begin (display shows "PUSH"
or "PSH")
Range is in Sabbath mode (display
shows "SAb")
Clean cycle did not Several cooking cycles between
work on all spills Clean cycles or spills on oven walls
and doors
Mineral deposits Tap water was used in the Clean
are left on the cycle
oven bottom after
the Clean cycle
Range is not level
22
Solutions
If propane gas is being used, contact a service technician. See the
back cover for more information.
See "Oven Temperature Control" in the "Electronic Oven Controls"
section.
This is normal. The convection fan will start running approximately
5 minutes into the cycle.
If the oven door is opened during convection cooking, the fan will
turn off immediately. It will come back on when the oven door is
closed.
Clear the display. On some models, reset the clock, if needed.
See "Clock" keypad feature in the "Feature Guide" section.
Depending on your model, press STOP to clear the display.
See "Control Display" in the "Electronic Oven Controls" section. If it
reappears, call for service. See the back cover for more information.
See the "Start" keypad feature in the "Feature Guide" section.
Press STOP to exit Sabbath mode.
Run additional Clean cycles. Kitchen and appliance cleaner
or cooktop cleaner can be used for stubborn soils.
Use distilled or filtered water in the Clean cycle.
To remove deposits, use a cloth soaked with vinegar. Then use a cloth
dampened with water to thoroughly remove any vinegar residue.
Mineral deposits will collect on dry areas of the oven bottom during
the Clean cycle. Level the range. See the Installation Instructions.
To remove deposits, use a cloth soaked with vinegar. Then use a cloth
dampened with water to thoroughly remove any vinegar residue.