To Obtain The Best Life For The Battery; Safety Features Incorporated With All Tools Using This Battery Pack - 909 CK14DD Instruction Manual

1 Connect the power output lead from the Plug Pack
Charger (3) to the back of the charger base (4).
2 Connect the plug pack charger (3) to a mains power
outlet (240Vac) and turn on. The green indicator light on
the charger base should glow.
3 Align the battery pack (1) with the entry of the charger
base (4). Fully insert the battery.
4 The red indicator light should now glow indicating the
battery is being charged. Green light should also remain
on.
5 When the battery is charged, the red light will turn off
leaving just the green power light on.
6 Remove the battery from the charger base and turn off
the Plug Pack Charger. The green light should go off.

To obtain the best life for the battery

Never allow the tool to completely drain the battery and
come to a complete stand still before recharging. The
battery should be placed on charge whenever the battery
is noticeably running down or the tool no longer performs a
task it previously performed. For storage, charge between
50 and 75%. Avoid allowing loose items like screws or nails
etc. to be stored with battery packs as these or similar items
can short battery packs and cause a fire or explosion.
Always unplug the charger when not in use and store in
a dry secure place.
Avoid charging or storing your battery in temperatures
below 0ºC and above 40ºC.
Safety features incorporated with ALL tools
using this battery pack
Product overload
These tools are fitted with an overload protection. If the
tool is excessively forced, or the task being performed is
too great for the tool, the tool will automatically go into
an overload mode. When the tool goes into overload, the
tool will automatically and suddenly STOP. To reset the
overload, simply release the trigger. When the trigger is
pressed again, the tool will restart. Resume work after the
overload has been reset, but reduce the load by using a
smaller drill bit or re-sharpen the existing drill bit and reduce
the amount of force placed on the tool.
CAUTION.
Do not continue to overload the tool and
constantly reset the overload. Doing this will cause the
battery cells to overheat.
Temperature cut out
If the tool is constantly overloaded, or the tool is used
constantly at maximum rating in high ambient conditions,
the battery cells may over heat causing the battery pack to
shut down.
The yellow indicator on the battery pack will stay illuminated
in this condition. When this occurs you will need to
immediately stop working and allow the battery cells to
reduce in temperature.
To reduce the temperature of the cells remove the battery
pack from the tool and place the battery pack in a free air
environment, out of direct sunlight or any other heat source.
DO NOT force cool the pack in any way. Do not place in
refrigerators or freezers.
When the battery pack has cooled down it can again
be used to operate the tool, as long as the load or the
15