CONTENTS Warranty Warranty Power Tools Introduction For full details please visit us at www.909.com Environmental protection Description of symbols Specifications General safety instructions Additional safety rules for sharpeners Contents of carton Unpacking Know your product Assembly Using the sharpener Maintenance...
Conforms to relevant standards special care to heed the Cautions and Warnings. for electromagnetic compatibility. Your 909 power tool has many features that will make your job faster and easier. Safety, performance, and For safe operation read instruction manual. dependability have been given top priority in the development of this tool, making it easy to maintain and operate.
General safety rules d. Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away WARNING. Read all instructions. Failure to follow all from heat, oil, sharp edges or moving parts. Damaged or instructions listed below may result in electric shock, entangled cords increase the risk of electric shock.
g. If devices are provided for the connection of dust 5. Service extraction and collection facilities, ensure these are a. Have your power tool serviced by a qualified repair connected and properly used. Use of these devices person using only identical replacement parts. This can reduce dust related hazards.
Due to modern mass production techniques, it is unlikely to run at full speed, or close to full speed during use. that your 909 Power Tool is faulty or that a part is missing. • Never apply excessive pressure to the wheel. It might If you find anything wrong, do not operate the tool until the shatter causing personal injury.
5. Slide the blade down towards the grinding wheel (2), Assembly make sure it just touches. Slide the plate away from Your sharpener comes boxed fully assembled with the the grinding wheel. modules all located on the power unit. 6. Switch the unit on, wait a second or two for the grinding Decide which module is to be used and remove all the other to get to full speed.
Page 9
3. Hold the knife handle and Sharpening high speed drill bits slide the handle end of the Note. Sharpens HSS drill bits from 3mm – 10mm. knife edge down the angled 1. Slide the high speed drill sharpening module (6) on the face until it touches the power unit until it clips securely into place.
8. Place fingers either side of the Cleaning module and rotate the module 1. Keep the outside of the sharpener/grinder clean by from side to side with slight brushing sharpening dust and dirt away from all areas pressure. where the dust tends to build up. 9.