CONTENTS Warranty Warranty Power Tools Introduction For full details please visit us at www.909.com Environmental protection Description of symbols Specifications General safety instructions Additional safety rules for heat guns Know your product Features Operation Fitting the accessories Using the heat gun on its stand...
Conforms to relevant standards special care to heed the Cautions and Warnings. for electromagnetic compatibility. Your 909 power tool has many features that will make your job faster and easier. Safety, performance, and For safe operation read instruction manual. dependability have been given top priority in the development of this tool, making it easy to maintain and operate.
General safety rules f) To reduce the risk of electric shock, the manufacturer recommends the use of a residual current device WARNING. Read all safety warnings and all instructions. with a rated residual current of 30mA or less at Failure to follow the warnings and instructions may result in all times.
4) Power tool use and care i) Children should be supervised to ensure that they do not play with the appliance. a) Do not force the power tool. Use the correct power tool for your application. The correct power tool will 5) Service do the job better and safer at the rate for which it was a) Have your power tool serviced by a qualified repair...
Page 6
Unpacking Due to modern mass production techniques, it is unlikely that your 909 Power Tool is faulty or that a part is missing. If you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been rectified.
Know your product 1. Heat nozzle 2. Guard sleeve 3. Body 4. LCD temperature indicator 5. Increase temperature button 6. Decrease temperature button 7. Increase fan speed button 8. Decrease fan speed button 9. Rear stand 10. Power cord 11. Heat range slide switch Accessories 12.
Features: Heat range selector switch. The heat range selector switch (11) is a 3 position slide Variable temperature control switch. The variable temperature control enables the temperature to These are: be set and adjusted between 50°C and 650°C, depending upon the type of material and the work to be carried out. Position 0: Stop/Off Position I:...
Follow the steps below to turn on and operate 1. Check to ensure the slide selector switch (11) is in the off the HG2000 heat gun. position (O). Plug in the mains cable into a 240V power To operate the heat gun at the outlet, and turn the power point on.
5. Select the air flow by pressing the top centre button to When the heat gun is placed down during breaks in the increase the fan speed, or the lower centre button to heating operation, the heat gun should always be placed on reduce the fan speed.
Power interruption Applications When using the heat gun, and the mains power is • Shrinking of shrink-down tubing, solder connectors and interrupted, the heat gun will stop. When the power is solder terminals, packaging and electrical components. reinstated the heat gun settings will resume to the previous •...
the National Institute of Safety and Health (NIOSH), or READ THESE INSTRUCTIONS the United States Bureau of Mines. These masks and WARNING: Extreme care should be taken when stripping replaceable filters are readily available at major hardware paint. The peelings, residue and vapours of paint may stores.
Maintenance WARNING. When performing any maintenance ensure the plug of the appliance is removed from the power source. Air flow through the heat gun is important. Keep the side air vents clear of debris and dirt build up by using a small brush.