CONTENTS Warranty Warranty Power Tools Introduction For full details please visit us at www.909.com Environmental protection Description of symbols Specifications General safety rules Additional safety rules for oscillating tools Accessories Unpacking Know your product Installing accessories Installing sandpaper Installing dust extraction fitting and adaptor...
Manual before using your new 909 Power Tool. Take For safe operation read instruction manual. special care to heed the Cautions and Warnings. Your 909 power tool has many features that will make Conforms to relevant standards your job faster and easier. Safety, performance, and for electromagnetic compatibility.
General safety rules f) To reduce the risk of electric shock, the manufacturer recommends the use of a residual current device WARNING. Read all safety warnings and all instructions. with a rated residual current of 30mA or less at Failure to follow the warnings and instructions may result in all times.
4) Power tool use and care i) Children should be supervised to ensure that they do not play with the appliance. a) Do not force the power tool. Use the correct power tool for your application. The correct power tool will 5) Service do the job better and safer at the rate for which it was a) Have your power tool serviced by a qualified repair...
Unpacking Due to modern mass production techniques, it is unlikely that your 909 Power Tool is faulty or that a part is missing. If you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been rectified.
Installing accessories All accessories are installed on the oscillating tool in a similar manner. For the purposes of describing the accessory installation, the plunge cutting blade is used. DANGER: Always remove the plug from the power source before installing or removing accessories or sandpaper. Failing to remove the plug from the power source may result in the tool accidentally being started and causing serious injury to the operator.
Notes: On/off switch a) Place the sandpaper so the holes in the sandpaper 1. To turn the tool ON, slide the line up with the matching holes in the hook & loop pad. ON/OFF switch (1) toward the front of the tool. b) Press the sandpaper firmly onto the hook &...
to provide a smooth surface for the blade to follow. Project Accessory Speed 3. Place the tool with the saw blade (3) lightly touching the surface of the tile and the cutting teeth NOT touching the Plasterboard Half circle blade Maximum surface to be cut.
on the flooring. plasterboard in the middle of one of the cutting lines. 3. Place the saw blade (2) near the floor surface in the middle of one of the cutting lines. 4. Set the speed to the highest speed and turn the tool ON. 4.
produce the smoothest surface. Maintenance It is recommended that the dust extraction system is used WARNING: When servicing, use only identical replacement when sanding. parts. The use of any other part may create a hazard or Using the scraper blade cause product damage.