Ready To Receive On Standby - AVM FRITZ!Card USB Installation Instructions Manual

CAPI SoftFax G3
The driver software allows FRITZ!Card USB v2.1 to be used with
all CAPI-based Windows fax applications. FRITZ!Card USB v2.1
sends and receives faxes at a rate of up to 14,4000 bit/s and
signals like any G3 fax machine.
CAPI SoftModem V32bis
FRITZ!Card USB also provides the CAPI SoftModem V32bis
feature. On the basis of this modem emulation, it is possible
to connect from an ISDN access to any analog remote party
with a modem connected to the telephone network.

4.3 Ready to Receive on Standby

If your computer supports ACPI (Advanced Configuration
Power Interface), you can take advantage of the energy sav-
ing features of standby and hibernation.
These two conditions differ in the following ways:
Standby: all devices that consume large amounts of
energy are turned off, such as the monitor, hard disks
and other devices.
Hibernation: also stores the contents of main memory
to the hard disk. In this condition energy consumption
is even lower than on standby.
Computers on standby or in hibernation appear to be
switched off. Both conditions are ended by operating the
keyboard or the power switch. Standby can also be ended
upon the request of a hardware component or an external
device, for instance, when a fax arrives through the ISDN-
Controller. When the fax program activates to accept the in-
coming fax, the energy-saving condition is ended.
FRITZ!Card USB v2.1 thus offers you the option of ending
standby operation for incoming faxes and calls by using the
"Remote Wake Up over ISDN" command. Once the computer
is reactivated, it checks whether a suitable program is ready
to accept the incoming call.
FRITZ!Card – 4 How Does Work FRITZ!Card
CAPI SoftFax G3
31